Help with the final pieces of the engine rebuild
Thread Starter
Member
Joined: Aug 2008
Posts: 81
Likes: 0
From: Roseville, CA
2002 c32 amg
Help with the final pieces of the engine rebuild
I am down to the final steps to get the C32 back on the road, but ran into a few small problems. The first one being the vacuum lines to the purge valves and supercharger. Does anyone have a good picture of how they are routed or a routing diagram. I couldn't tell from the EPC how they go from the part at the front of the engine where there are two vacuum lines coming out.
The second being I have a small brown, grounding, wire that I can't remember where it came from. I believe that it was attached to an accessory of some kind, either the power steering pump, or AC compressor. Its about 6" in length and has eyes on both ends for a bolt to go through.
Any help is greatly appriciated, as always.
Thanks
The second being I have a small brown, grounding, wire that I can't remember where it came from. I believe that it was attached to an accessory of some kind, either the power steering pump, or AC compressor. Its about 6" in length and has eyes on both ends for a bolt to go through.
Any help is greatly appriciated, as always.
Thanks
MBWorld Fanatic!
Joined: Dec 2007
Posts: 5,034
Likes: 6
From: Corona, CA
03 g35 coupe...........02 c32 Sold
MBWorld Fanatic!
Joined: Mar 2007
Posts: 1,948
Likes: 3
From: Houston, TX
C32/C55 AMG
There should a ground cable connected to the power steering pump, looking over the pump from the front of the car, it would be on the bottom right hand side. There are 3 bolts total that are used on the back of the power steering pump, so see if that one is missing.
I'll be happy to take some pics, just let me know where.
Here are some pics that I have of my engine bay.
I'll be happy to take some pics, just let me know where.
Here are some pics that I have of my engine bay.
