FROZEN BOOST 26x7x2 Heat Exchanger
#52
MBWorld Fanatic!
Thread Starter
Why do you ask? No, and anyone would be me I guess since I'm the only one to have used this H/E so far. In fact the valve took a huge hit when I overlooked a large pot hole in a parking lot. Tore off one of the tabs, and hit the valve hard. No issues... I've had several people ask me if the 3.5" should fit. YES, I believe it will fit with the correct mounting. Slight trimming of the bumper, and underbody panel will probably be required.
#53
Junior Member
Join Date: Feb 2011
Location: Texas
Posts: 50
Likes: 0
Received 1 Like
on
1 Post
C32 AMG (sold) E55 AMG
I actually went ahead and finished up the install of my own F/B. I was getting a few drops of coolant for the first day or two every now and again, however, I've been running it for a few months now with no signs of leakage. I suppose it just worried me at first, no big deal now though. Thanks!
#54
MBWorld Fanatic!
Thread Starter
The valve is completely shut when the push bar is level horizontal. I believe from the factory mine came set a little up, and would have leaked as well without adjusting. By the way, which one did you go with? The 2" or 3.5"? Also, did you notice the difference? Know I did...
#56
MBWorld Fanatic!
Thread Starter
Good to hear! What size did you go with the 2", or 3.5"? Give some details as to your install method and any modifications required.
#58
MBWorld Fanatic!
Thread Starter
Same here noticed a big difference. Glad it worked out for you! Here's another photograph don't think I uploaded. Taken during install...