Cammer88

507 LSD installed, H&R springs installed, flex plate replaced! Successful weekend.

Jasonoff

Added a little downforce.

roadkillrob

A little of a lot of downforce!

Jasonoff

Yeah it's 71" so whenever I end up increasing the front downforce with dive planes, fender louvers etc, I won't have much trouble increasing the rear with minor adjustments.

Fully braced trunk lid as well. The pic from the rear makes it look massive.

deadlyvt

Ya that looks massive! Like insane massive haha definitely produce some downforce with that

dfreret

Is that the XF Motorsports wing ?

Nukleuz

Those look like stock 507 rims? What size tyres are you running? stock 255 ?

Jasonoff

Yeah

thebug44

Yea they are original 507 wheels I had refinished. 265 in the rear and 245 in front I think

Dr.Speedfellow

Are you running different brand and compound front and rear? Because 245/35r19 toyo r888r would not be properly load rated for the car, for the load rating to be correct it would be a 235/35r19 r888r

Drifter2090

Just got my 08 C63 and wanted to freshen it up. Plugs, injectors, fluids, filters, intake manifold gaskets, pcv hose, alignment.

The M156 is a very easy engine to work on so far.

It had no issues and drove well before but now its way smoother! Idle feels way smoother as well.

Nukleuz

I just installed my black badges.

hachiroku

for my E63, totally felt the lack of frontal downforce and possibly air being trapped in the front fenders during high speed straights on the track. exciting work here!

Jasonoff

Dive planes and fender louvers are on the list to tinker with during the season. Now that the front splitter is strong enough to stand on with these center rods mounted to the bumper beam.

First time having aero like this so it's going to be a learning experience.

sventastic82

Installed an oil pressure gage and sensor.

Jasonoff

How many cuts on your hands?

sventastic82

My right forearm looks like it was attacked by a cat.

BLKROKT

Did you plumb that into the unused port on the oil filter housing? I was about to do the same thing while I have things apart.

What gauge is that?

VektorPerforman

I like the ashtray location. Looks like a great location to mount, plus super easy to convert back to stock.

Kriston

J im thinking about taking my car to XF ( Shehryar) to do the bolts and transmission service. How was your experience with him?

sventastic82

Yes, I used the unused port in oil filter housing.
this is the gage.

Ebay

Jasonoff

He's good, just pretty busy with all the projects he has going on. I went there last year for an alignment then this year for the custom wing.

Stand up guy.

Cammer88

Took my bone stock 2011 C63 to the dyno for a baseline run. The dyno used was a Dyno-Mite which tend to read 10% lower than a dynojet.

Drifter2090

Looking good man! How bad was the LSD install? I've had my P30 LSD sitting in my basement for a while now lol.

Also what size spacers and tires are you running on the oem 5 spoke?

Cammer88

LSD wasn't bad at all actually, took me about 3.5hrs in the garage on stands. If you're planning on doing it have a new drive shaft flex joint ready as yours is probably starting to tear. I'm running 12mm spacers on all four corners with 245F/265R tires.

I will say that the the LSD makes a world of a difference.