anyone got them? I'd rather not open up the door and try to figure it out myself

edited to specifiy exterior door handles

I will post up later, had computer problems and have to reinstall the WIS

Hope this helps

thanks dynomite, but it still looks a little confusing. lol

i'll give it a try tomorrow though.

have you actually taken apart the handle before?

Haven't done it before but it looks like its just a couple steps.

Unclip seal on the edge of the door
Unscrew bolt
Pull out lock and disconnect
Pull out handle

blah,i took off the cylinder and sensor and disconnected it, but still am unsure on how to remove the handle itself.

It says pull out bearing bracket towards rear...lol

nevermind, i just gave it a yank and it came out, haha. i thought it was more complicated than that.

Glad to see it worked. BTW why do you need to take the handle out?

prepping my car to vinyl it a different color.

i'll post pics when im done

sorry for keep bothering you dynomite, would you happen to have instructions on removing the side skirts and rear bumper also? i found your post on removing the front bumper and i did a search for side skirts but a lot of the threads have not been answered.

I would be able to get the instructions when I get back to work tomorrow. Don't have the WIS at home...

Here are the instructions for the Rear Bumper and the Fender Liner

This is for the Truck Paneling, SAM Control, and the side skirts