Help with w209 clk500 to convert to clk55
A friend of mine wants to drop a clk55 engine in his facelift 2004 with amg bodykit, and needed a bit more info about what has to be done?
I sit a straight engine swap or some coding or something else has to be doing?
His clk500 done about 160k miles and he found an engine from 55 with 74000 miles.
Thanks




Engine family M113, only the intake manifolds will differ.
The exhaust should be replaced but it should bolt up.
No coding required but to utilize the performance of the 5.5 tuning is recommended especially if the exhaust is modified.
A 5.0 ECU might have ME 2.8 coding don't know. To swap ECU flashing required.
hope this helps a bit.
Cheers, Gator




I believe the twin cam engine started in 06 or 07. The M113 was up to 2005 but the transmission was upgraded to the 7 speed.
I can be wrong.
regardless it should be a bolt in with little coding.
Cheers
Just don't show it off as a true AMG. Some folks get offended.
Last edited by GatorMB; Sep 5, 2016 at 08:46 PM.
Trending Topics




The Best of Mercedes & AMG
he was going to give up and leave the car with them now I'm going to buy it off him and go forward with the swap.
2004 5 speed gearbox m113 5.0 engine facelift model with sat nav wide screen command.
Do I need the manifold and diff with the donor engine ecu or looms what do you guys think?
Last edited by MarcusF; Sep 10, 2016 at 01:02 PM.
the key opens the ignition but when you turn to start it up it doesnt crank it does nothing at all
any clue where to start from?
the mechanic i showed it today to went through everything and managed to start the car with the wire connected to starter relay in SAM unit.
when you earth the wire the car starts from the key if not earthed doesnt i suggested him it might be a starter motor but he ruled it out saying it wouldnt startat all if that was a starter motor I dont know if he right or not.
suggestions guys please?
I should have used A CLK55. Long story short I had the same problem it wouldn't start I did a drive authorization through the xentry And have fixed it
the key opens the ignition but when you turn to start it up it doesnt crank it does nothing at all
any clue where to start from?
the mechanic i showed it today to went through everything and managed to start the car with the wire connected to starter relay in SAM unit.
when you earth the wire the car starts from the key if not earthed doesnt i suggested him it might be a starter motor but he ruled it out saying it wouldnt startat all if that was a starter motor I dont know if he right or not.
suggestions guys please?








