turn off automatic headlamp washers?
I just don't know why it started doing this now, i think i activated something somehow. weird.


It's in relay box F1, relay code "D", Designation K2- whatever all that means. The document is 5 megs or I would upload it.
Last edited by shdoug; Feb 3, 2008 at 03:19 PM.


Trending Topics
now i'm out of washer fluid and one of the wipers is pointing straight up. i can get to the driver's side plug easily, but the passenger side is a b!tch... and i'm not sure unplugging them will prevent it from squirting fluid still...
The Best of Mercedes & AMG


now i'm out of washer fluid and one of the wipers is pointing straight up. i can get to the driver's side plug easily, but the passenger side is a b!tch... and i'm not sure unplugging them will prevent it from squirting fluid still...
Zeddy, Seems like it's a relay problem.
At first I thought you just had your lights on along with the foglights which enable the headlight wipers to go on when you use the windshield wipers but I read your question wrong. lol


Zeddy, Seems like it's a relay problem.
At first I thought you just had your lights on along with the foglights which enable the headlight wipers to go on when you use the windshield wipers but I read your question wrong. lol
what i'm going to do is put a piece of plastic or something in there so when the relay closes, it doesn't make contact so the wipers don't come on.
my question is, does this relay do anything else, or is it just for my wipers? if it's just for my wipers, then i can either block the relay, or just remove it altogether...
this is the relay when it's open, i circled where the contact is:

this is when the solenoid closes the relay (i used a screw driver to push it closed). You can see the tiny spring that keeps tension on the gate when it closes, that pulls it back open. amazing little piece of machinery!
edit: okay, i lied, the turn signals still work! i'm just going to remove the relay, and hopefully problem solved!
Last edited by ZedStyle; Feb 23, 2008 at 04:30 PM.


I can't believe it- page 163 is missing from my manual!!! That's the page that shows where those contacts feed. Regardless, according to the diagram that relay should not energize until Combination Switch S4 is closed. I think your problem is a bad contact on the turn signal stalk combo switch (S4). Although the diagram seems to indicate that this would cause the windshield wipers to also operate all the time.

Update: Found the missing page! That relay only powers the headlamp wipers/washer pump so if you disconnect it nothing else should be affected.
Last edited by shdoug; Feb 23, 2008 at 06:06 PM.



