W164 Front Suspension Torque Specs.
#1
W164 Front Suspension Torque Specs.
Does anyone know the torque specs for a 2008 ML550 with non-air suspension? Specifically: Axle nut to hub, Upper ball joint to spindle, Tie rod to spindle, upper strut mount and sway bar to strut.
Thanks in advance! Ray G
Thanks in advance! Ray G
Last edited by onequickcobra; 10-30-2018 at 10:20 AM. Reason: Forgot one spec.
The following 3 users liked this post by Maj. Dundee:
#5
Thanks so much for the specs.! I'm sorry to get back so late, but I was away from the project for the last week. The vehicle has a strut suspension, so I believe that the correct spec. for the axle nut is 260 NM, + 45 degrees. I can't find the upper strut tower to chassis mount specs for the 3 nuts, and the torque spec for the coil spring assembly retaining nut for the top of the strut if you happen to have them. Thanks again for all your help!!! Ray G.
The following users liked this post:
DrkNyte (03-10-2020)
The following users liked this post:
onequickcobra (11-07-2018)
#7
I appreciated the quick response and tool suggestion; it will come in handy for sure! Do you happen to know what the torque is for the single nut holding the coil spring pack to the top of the strut? Thanks again ! Sincerely, Ray G
Trending Topics
#8
MBWorld Fanatic!
Here it is and I hope this is the end of it.
Warning: that the spring is loaded and can only be done with special spring compressor.
Warning: that the spring is loaded and can only be done with special spring compressor.
Last edited by Maj. Dundee; 11-09-2018 at 04:40 AM.
The following users liked this post:
MJML550 (12-27-2020)