S600 won't stay started
#1
Thread Starter
Junior Member
Joined: Nov 2021
Posts: 26
Likes: 2
From: Toledo ohio
2001 s600,95 c220
S600 won't stay started
S600 sputters and won't stay started. I just replaced both coil packs. put it all back together and now it won't even stay started. Before the replacements had several misfires. Just got the car from an older couple and they had taken it to the dealer and they had said it needed both coil packs. So I replaced them. it ran and stayed started before the replacement.
#3
Thread Starter
Junior Member
Joined: Nov 2021
Posts: 26
Likes: 2
From: Toledo ohio
2001 s600,95 c220
Yes, it won't run. Before the replacement I had p101, 02, 03, and so on. I think it was running on like 3cylinders. After I replaced put a scanner on and it had a maf code. So I replaced that. Still nothing. I can try to get the codes again. I know we erased them in hopes it would run and if not it would pop up new codes.
#7
You need DAS/XENTRY - not some code scanner. The codes for engine misfire are P3XX, not P101, etc. as you listed.
Right now, you're guessing at a cause. It could be lots of things. I have to wonder about your scanner showing a MAF code.
There isn't a MAF on the V-12. So, your scanner is basically worthless. Get the proper tool, and re-do the scan to begin a proper diagnosis.
Right now, you're guessing at a cause. It could be lots of things. I have to wonder about your scanner showing a MAF code.
There isn't a MAF on the V-12. So, your scanner is basically worthless. Get the proper tool, and re-do the scan to begin a proper diagnosis.