Anyone know what "model number" our cars are?
06-07-2011, 10:59 PM
#5
Super Member
Thread Starter
Cool. Here's what the manual says:
Model 210.074/274/083/283
Front:
New 32 mm (1.259 in.)
Wear Limit 29.4 mm (1.157 in.)
Service Limit 30 mm (1.181 in.)
Rear:
New 22 mm (0.866 in.)
Wear Limit 19.4 mm (0.763 in.)
Service Limit 20 mm (0.787 in.)
Model 210.074/274/083/283
Front:
New 32 mm (1.259 in.)
Wear Limit 29.4 mm (1.157 in.)
Service Limit 30 mm (1.181 in.)
Rear:
New 22 mm (0.866 in.)
Wear Limit 19.4 mm (0.763 in.)
Service Limit 20 mm (0.787 in.)
06-12-2011, 11:48 PM
#7
Trending Topics
06-13-2011, 12:08 AM
#8
MBWorld Fanatic!
Here is a pic of my rotor (its off a C43 but I believe the C43 and E55 used the same brakes, it has a 210 part number)
It says 30.4mm on the rotor hat (crappy iphone pic)
Here is a screen shot from the WIS that states the limit was reduced from 30.4mm to 29.4
It says 30.4mm on the rotor hat (crappy iphone pic)
Here is a screen shot from the WIS that states the limit was reduced from 30.4mm to 29.4
08-14-2011, 10:31 AM
#9
Super Member
Thread Starter
Just did my brakes and saw this mark. It should be mentioned that this mark is not useful if you do not turn your discs. No pads wear down the outer edge which means if you do if you just replace pads (which is typical), the wear indicators are never reached but the disc itself is as thin as it is. It must be measured
