82mm t/b install??
#1
Super Member
Thread Starter
Join Date: Nov 2006
Location: Miami,FL.
Posts: 809
Likes: 0
Received 0 Likes
on
0 Posts
2017 Charger Hellcat
82mm t/b install??
Installing a 82mm t/b,not sure where the two vent hoses go that are from the back of the valve cover gaskets to the stock t/b..The t/b that is being istalled does not have a place for those two hoses,what do we do??
Thanks,
Miguel
Thanks,
Miguel
#2
MBWorld Fanatic!
The 2 small hoses (one for each side of the back of the valve covers) go into a T that connects to TB. Your 82TB should have nipple to which the T will connect.
#5
Former Vendor of MBWorld
iTrader: (1)
Join Date: May 2008
Location: Houston
Posts: 12,139
Received 293 Likes
on
242 Posts
2003 W211 E55, 2003 W220 S600
The bosch tbs don't have the inlet, you can just vent the 2 tubes to the atmosphere, just put a small breather filter at the end of them.
Now if you still want to connect it to the tb, drill and tap a hole in the tb after the butterfly and put a threaded brass barb fitting
Now if you still want to connect it to the tb, drill and tap a hole in the tb after the butterfly and put a threaded brass barb fitting
#6
MBWorld Fanatic!
Agreed. Some of the compatible Bosch TB's do not have the breather connection. I would vent to atmosphere, as Shardul said, using a small filter to catch oil, and prevent sucking in dust, dirt, bees
Good luck with install
Good luck with install
#7
MBWorld Fanatic!
The bosch tbs don't have the inlet, you can just vent the 2 tubes to the atmosphere, just put a small breather filter at the end of them.
Now if you still want to connect it to the tb, drill and tap a hole in the tb after the butterfly and put a threaded brass barb fitting
Now if you still want to connect it to the tb, drill and tap a hole in the tb after the butterfly and put a threaded brass barb fitting
Trending Topics
#9
Super Member
Thread Starter
Join Date: Nov 2006
Location: Miami,FL.
Posts: 809
Likes: 0
Received 0 Likes
on
0 Posts
2017 Charger Hellcat
The bosch tbs don't have the inlet, you can just vent the 2 tubes to the atmosphere, just put a small breather filter at the end of them.
Now if you still want to connect it to the tb, drill and tap a hole in the tb after the butterfly and put a threaded brass barb fitting
Now if you still want to connect it to the tb, drill and tap a hole in the tb after the butterfly and put a threaded brass barb fitting
#10
Former Vendor of MBWorld