urbamworm

If anyone is looking for a tank to use to change their supercharger intercooler system over to a separated setup I have my old tank for sale. It was $105 new for the tank only (no fittings, no cap). It also has npt fittings installed (3/8 on side and 1/2 on bottom) in it to connect the hoses up for the feed and return and a 90 degree fitting on the bottom that will come with the tank to connect your feed line to as well as a nice cap installed. So there is another $35 in stuff there ($140 total). A 3/4" hose fits the bottom connector and the return port is 5/8" and then the small hose you see off the right side is just a little overflow hose.

I have it sitting in my garage and figured someone else could use it. I will sell it with all stuff seen in the pics for $75 shipped. The dimensions are 5 1/2" long by 4 1/2" wide by 3" thick and it holds 1 1/4 quarts of fluid.




It was installed up in the front bumper area above the heat exchanger but you may choose another spot.





If it is fitted in to the same area in front bumper you will need to get some hoses and/or fittings with some 90 bends to route the hoses to the heat exchanger pump, etc. Some cheap little plastic fittings were used before.

Again price shipped is $75

berti_00

if i didnt buy the damm cobra reservoir i would of jumped on it

Mr-Uli

is that small enough to fit in the engine bay like the little bmw res?

99lightning

sure is.

berti_00

hows your cobra tank so far? good?

urbamworm

I suppose so, it could fit somewhere. It has those two flat tabs on each side to mount with, I guess you would need to make something to connect to that or figure out a spot where could use those to secure to something.

Here is more pics to give you visual aid of size. 20oz Gatorade and Mountain Dew can.

cij911

Great deal....GLWS

pearlpower

Looks like a solid tank, good price, GLWS.