nemiro

Wondering if there was posted anywhere a belt size chart for the supercharger? I have a BWK, currently, but in my particular application, if something happens to the belt, it is a major disassembly operation, due to the tight engine bay. Eliminating the BWK will make it to where a belt can be replaced on the road. As I have changed my setup from a smaller upper pulley to a stock 90mm upper and a 180mm lower, the BWK is doing less work, anyway.

If not a chart, does anyone know the belt size for a 180mm lower and stock upper, without the BWK?

nd-photo.nl

From Creative steel website: https://creative-steel.com/shop/merc...t-wrap-kit-06/

nemiro

Thank you! This is WITH the BWK, so it is a good reference to have here. I am looking for a belt size without the BWK, and with a 180mm lower pulley.

nd-photo.nl

I know i saw it somewhere, but i cant remember where. Please note that BWK without the bracket exists!

I also started a thread about it as I want to know more about it (but you knew that :P ): https://mbworld.org/forums/w211-amg/...t-bracket.html

Fountain35

Post some pics of the Crossfire and the 113 swap.

nd-photo.nl

Or even better, create a thread for it if it doesnt exist yet

nemiro

I do have a thread on it that I try to maintain on the Crossfire forums. https://www.crossfireforum.org/forum...e-journal.html

I have been powdercoating and changing up the underhood color scheme, but mechanically, mostly the same as here.



edit: forum stripped off the pics. Trying again.

nd-photo.nl

Cool!

Did you notice something after adding the bridged plenums?

nemiro

Nothing I could quantify. However, Needswings tested this concept quite a bit, and swears by it. I purchased them, but remain skeptical. This version has only one tube, as I have potential hood clearance issues if there were two.