Removing trunk lid liner to remove rear emblem?
Thanks in advance
X
X
X
So, why not just remove the trunk lining to gain access to the rear of the posts?
I'm kidding.
Please figure this out so I can get it done, too.
Trending Topics
One of these:
Work it behind the fastener head and wiggle just a little while you lever it out.
But this is not a ten minute job. There are a lot (!) of fasteners and layers of trim.
I'm going to try spraying the star one more time while it's in situ. If it doesn't work this time, I may just call it a day and leave it chrome.
The Best of Mercedes & AMG
I figured out how to get the rear emblem off and the trunk liner down. Luckily I purchased a second emblem before the process started since I destroyed the one on the car getting it off.
To get the trunk liner down, I hooked my fingers under the liner at the back, top of the liner. If the trunk is open, you will be looking straight at 4 plastic retaining clips where I started. I used my fingers and a plastic tool used to remove panel clips. Then I did the clip holding the plastic molding to the hinge. Unfortunately I broke the little strap clips off of the molding as I was trying to slide it out of the way, but I held it in place with zip ties when I was putting everything back together.
There are an additional two retaining clips along the back, side of the liner I removed to be able to peel the liner back enough to get to the back of the emblem. You can see the 3 rubber grommets around the emblem post and the posts sticking out. I pushed them partially out (and crushed them) from the back and then used a plastic wedge on my clip remover too to essentially pry the emblem off (and destroying it in the process).
I then stuck the new emblem to a piece of cardboard to plastidip it. The emblem then just pushed into the 3 rubber grommets you can see in the picture. That is it!
X
Last edited by 335X-ray; Nov 24, 2013 at 04:58 PM.
I reused the rubber grommets. They combine with the posts on the emblem to create friction and keep things snug and water tight. One of the grommets fell out as I was shoe horning the emblem out and I just gently pushed it back into the whole in the trunk and then pushed the emblem posts into the grommets.
Hope that helps,
X

X


dec·i·mate
ˈdesəˌmāt/
verb
verb: decimate; 3rd person present: decimates; past tense: decimated; past participle: decimated; gerund or present participle: decimating
1.
kill, destroy, or remove a large percentage or part of.
"the project would decimate the fragile wetland wilderness"
drastically reduce the strength or effectiveness of (something).
"plant viruses that can decimate yields"
2.
historical
kill one in every ten of (a group of soldiers or others) as a punishment for the whole group.


dec·i·mate
ˈdesəˌmāt/
verb
verb: decimate; 3rd person present: decimates; past tense: decimated; past participle: decimated; gerund or present participle: decimating
1.
kill, destroy, or remove a large percentage or part of.
"the project would decimate the fragile wetland wilderness"
drastically reduce the strength or effectiveness of (something).
"plant viruses that can decimate yields"
2.historical
kill one in every ten of (a group of soldiers or others) as a punishment for the whole group.deci·mation n.

Consistent with but cannot exclude...clinical correlation suggested


X
...
Consistent with stabbing, but cannot rule out flesh wound. Consult Black Knight.

When the phrase is used to mean that something is equivocal and that the person who puts his hands on the patient or examines them needs to put all the pieces together, it is totally warranted. Isolated imaging findings can mean one of several things and by themselves, sometimes you can't tell.
Yes, I agree, some people use the phrase at the end of every report in some way trying to cover their butt, but some of us try not to do that.
Sorry to be a bit testy, but I don't like being generalized.
X
X



