New high flow intake design.
#77
Super Member
Thread Starter
these are prototypes only that your seeing, rushed printed cutting some corners for basically just dialing in fitment. it will be printed for now. But a slow continuously printed high temp high strength carbon composite . Triple thick. It's very nice , very strong. Very very light . Cools of extremely fast. At some point tho we will most likely move to getting a mold then abs. Especially if we want to keep up with the demands . So it all depends how it goes . But I prefer the print even tho the materials and the amount used isn't super cheap.
Last edited by Cifdig; 01-18-2024 at 06:37 PM.
#78
Super Member
Thread Starter
#79
Super Member
Thread Starter
@Cifdig these really look so well made as if they were OEM factory! Amazing work! Doest look like the hood liner gets touched/scratched by these in any way and its a nice clean seal/fit of the hood?
I have one of the early days blackboost kits with the larger diameter red BMC filters which were about 1/4 inch too wide diameter and stuck out above the boxes so my hood liner got a little messed up with wear marks...
I have one of the early days blackboost kits with the larger diameter red BMC filters which were about 1/4 inch too wide diameter and stuck out above the boxes so my hood liner got a little messed up with wear marks...
thx bud. So here's the thing . The problem with the hood meeting the hood liner isn't so much the height of the box, the problem is the movement of the engine. Our engine move up and to the left , so unfortunately even if you left a gap between the hood and the box , unfortunately it will still touch and if your motor mounts fail it will be even worse. But we spent time making sure the fitment was as clean as
possible
#80
Super Member
Thread Starter
![](https://cimg2.ibsrv.net/gimg/www.mbworld.org-vbulletin/1099x683/1fdd279a_a9fd_4a60_9acc_390c3b11d4a6_3e3b719de00cf42e70898046b12fca704b3ee0d9.jpeg)
![](https://cimg4.ibsrv.net/gimg/www.mbworld.org-vbulletin/1170x1423/624a8498_ec11_44e6_8acc_81c6b034627f_ae53f5f538c08040aa57ee6fac54057f7c58bdda.jpeg)
![](https://cimg6.ibsrv.net/gimg/www.mbworld.org-vbulletin/1170x846/afbcd65e_331d_4333_9967_bb3bdfe9990e_da01912e067541a159d892c22d8d5374182c6de0.jpeg)
Meth nozzle placement. These intakes combined with pre turbo meth injection is such a big win. Look at the size of this 3" joiner. These are going to be a must for anyone who takes efficiency and power seriously.
Last edited by Cifdig; 02-04-2024 at 05:06 PM.
The following 3 users liked this post by Cifdig:
The following users liked this post:
I.T. Guy (02-05-2024)
The following 2 users liked this post by Faast:
I.T. Guy (02-05-2024),
OldManAndHisCar (02-05-2024)
The following users liked this post:
Hammer Down (02-13-2024)