Audio 10 install - programming question
Thread Starter
MBWorld Fanatic!
Joined: Jun 2002
Posts: 1,249
Likes: 17
From: Chicagoland, IL
09 C63
Audio 10 install - programming question
I am putting my audio10 in shortly and ran across this while looking for aux input options:
What does this mean? Does anything have to be done after doing the wiring part of the install? Is this a DAS thing?
I want to make sure before I lock it out.
Peet
Theft protection is handled by a unit identifier signal over the CANBUS with the vehicle (the devices have no code). This identifier is checked at each operation of the unit. If this identifier is missing, then the radio goes into the PROD lockout mode and can no longer be operated.
I want to make sure before I lock it out.
Peet
Senior Member
Joined: Jul 2002
Posts: 330
Likes: 0
From what I have been told by Buellwinkle, thier is no problem in putting that radio in your C230K. This thread may help;
this is the installation of one and some good comments
https://mbworld.org/forums/showthrea...threadid=13302
this has some information on the radio
https://mbworld.org/forums/showthrea...threadid=16689
this is the installation of one and some good comments
https://mbworld.org/forums/showthrea...threadid=13302
this has some information on the radio
https://mbworld.org/forums/showthrea...threadid=16689
Member
Joined: Mar 2002
Posts: 154
Likes: 0
From: D/FW Texas
C230K
Peet
TO cut a long story short, I put an Audio 10 in my car, and no programming was necessary. The steering wheel controls also worked, as well as speed sensitive volume. It even controls the CD changer.
Of course, a working Audio 10 is a prerequisite...
TO cut a long story short, I put an Audio 10 in my car, and no programming was necessary. The steering wheel controls also worked, as well as speed sensitive volume. It even controls the CD changer.
Of course, a working Audio 10 is a prerequisite...
