TemjinX2's $20 seat control battery drain fix
#27
Senior Member
Maybe a stupid question, but I haven't been "inside" yet to access the modules, but:
How do you access the cigarette lighter wiring? Is it right there in the floor by the seat module?
Also, do you know which fuses are the seat controls? I'd like to disable them in case I don't get this right the first time so I can give my mother in law her car back.
Thanks
How do you access the cigarette lighter wiring? Is it right there in the floor by the seat module?
Also, do you know which fuses are the seat controls? I'd like to disable them in case I don't get this right the first time so I can give my mother in law her car back.
Thanks
#28
MBWorld Fanatic!
Thread Starter
Join Date: Dec 2007
Location: Corona, CA
Posts: 5,034
Likes: 0
Received 6 Likes
on
6 Posts
03 g35 coupe...........02 c32 Sold
Maybe a stupid question, but I haven't been "inside" yet to access the modules, but:
How do you access the cigarette lighter wiring? Is it right there in the floor by the seat module?
Also, do you know which fuses are the seat controls? I'd like to disable them in case I don't get this right the first time so I can give my mother in law her car back.
Thanks
How do you access the cigarette lighter wiring? Is it right there in the floor by the seat module?
Also, do you know which fuses are the seat controls? I'd like to disable them in case I don't get this right the first time so I can give my mother in law her car back.
Thanks
https://mbworld.org/forums/c32-amg-c...at-module.html
you can access there cig lighter from the center console and run it under the panels or you the aux accel from the rear sam.
I'll see if i can find the instructions from the v1 diy
#29
MBWorld Fanatic!
Thread Starter
Join Date: Dec 2007
Location: Corona, CA
Posts: 5,034
Likes: 0
Received 6 Likes
on
6 Posts
03 g35 coupe...........02 c32 Sold
here's a diy to access the aux 12v accel from the rear sam.
https://mbworld.org/forums/c-class-w...ll-please.html
https://mbworld.org/forums/c-class-w...ll-please.html
#31
MBWorld Fanatic!
Thread Starter
Join Date: Dec 2007
Location: Corona, CA
Posts: 5,034
Likes: 0
Received 6 Likes
on
6 Posts
03 g35 coupe...........02 c32 Sold
you can access the cig lighter directly under the center console.
directions here.
https://mbworld.org/forums/c-class-w...lp-please.html
then you can run the wires like they did here, under the panels.
https://mbworld.org/forums/c-class-w...e-warning.html
then you can run the wiring to the side then under the door sills. There's a cut in the oem carpet by the door sill near the seat control modules. You can run the wire there from under the door sill
directions here.
https://mbworld.org/forums/c-class-w...lp-please.html
then you can run the wires like they did here, under the panels.
https://mbworld.org/forums/c-class-w...e-warning.html
then you can run the wiring to the side then under the door sills. There's a cut in the oem carpet by the door sill near the seat control modules. You can run the wire there from under the door sill
#33
Senior Member
Thanks, Temjin. This will make my Christmas project a lot easier. I'm going to do the relay solution, but if I have too much trouble, I might opt for the switch.
Thanks!
Thanks!
#35
Junior Member
Join Date: Jan 2006
Location: Boston, MA
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
'95 e320 Wagon, '92 300TE
Is this an issue on '03 and '04 c - class cars?
Hi,
I just bought an '04 C320 wagon. Does anyone know if Mercedes fixed this issue (seat control module battery drain) on the '03 and '04 models? I'm assuming they did as I haven't seen any posts/complaints from '03-'04 models.
thanks,
Michael
I just bought an '04 C320 wagon. Does anyone know if Mercedes fixed this issue (seat control module battery drain) on the '03 and '04 models? I'm assuming they did as I haven't seen any posts/complaints from '03-'04 models.
thanks,
Michael
#37
Junior Member
Join Date: Jan 2006
Location: Boston, MA
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
'95 e320 Wagon, '92 300TE
#38
Super Moderator
I have the entire post 2003 DB W203 Facelift tome and with all the upgrades done & the move to CAN system, MOST etc - there is no update recorded for these modules. I can only believe that they tightened up QC on them from the OE supplier. It is possible that they were updated before the end of 2003 of course but I find no record of that.
Last edited by Glyn M Ruck; 02-13-2009 at 07:52 PM.
#39
MBWorld Fanatic!
Thread Starter
Join Date: Dec 2007
Location: Corona, CA
Posts: 5,034
Likes: 0
Received 6 Likes
on
6 Posts
03 g35 coupe...........02 c32 Sold
I think its the 05's that got the new seat control modules. I believe they use the same ones as the newer e55's. I remember topgun mentioned it in his other thread.
#40
MBWorld Fanatic!
Thread Starter
Join Date: Dec 2007
Location: Corona, CA
Posts: 5,034
Likes: 0
Received 6 Likes
on
6 Posts
03 g35 coupe...........02 c32 Sold
the older models has a 203 in the part number the new updated modules start with a 211.
the old seat modules
We talked about on this thread before i came up with the relay fix
https://mbworld.org/forums/c32-amg-c...tible-c32.html
We talked about on this thread before i came up with the relay fix
https://mbworld.org/forums/c32-amg-c...tible-c32.html
#41
MBWorld Fanatic!
Thread Starter
Join Date: Dec 2007
Location: Corona, CA
Posts: 5,034
Likes: 0
Received 6 Likes
on
6 Posts
03 g35 coupe...........02 c32 Sold
Basically all the older modules or the ones that have 203 will all eventually have the same battery draining issue. I'm convinced all them are crap. The new 211 seems to not have the issue. At least thats the feedback i read from some of the members on the c32 forum who replaced it with the new part.
#43
Junior Member
Join Date: Jan 2006
Location: Boston, MA
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
'95 e320 Wagon, '92 300TE
I have the entire post 2003 DB W203 Facelift tome and with all the upgrades done & the move to CAN system, MOST etc - there is no update recorded for these modules. I can only believe that they tightened up QC on them from the OE supplier. It is possible that they were updated before the end of 2003 of course but I find no record of that.
I'd rather not fix it if it's not broke but would like to know what to look for.
thanks again,
Michael
#44
Super Moderator
Hey Mike, Thanks for clarifying - so they must have done them as a running update and not at Facelift time. Great that we have a part number now. Would be interesting to find a date or VIN at which they changed - That could prove difficult
#45
Super Moderator
Yeah, this would make sense (that they tightened up quality control)...I've yet to hear of anyone with a 2003 or 2004 who has experienced this problem. Again, I just bought an '04 C320. Will I hear a buzzing noise when it starts to malfunction and pull too much from the battery?
I'd rather not fix it if it's not broke but would like to know what to look for.
thanks again,
Michael
I'd rather not fix it if it's not broke but would like to know what to look for.
thanks again,
Michael
BTW - I don't know anybody in South Africa that has ever had this problem so I wonder whether there were not multiple suppliers of this module.
Mike says made in Portugal due to Portuguese language on components. I think more likely made in Brazil when many W203s were manufactured for the US market there.
Last edited by Glyn M Ruck; 02-14-2009 at 08:45 AM.
#46
Junior Member
Join Date: Jan 2006
Location: Boston, MA
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
'95 e320 Wagon, '92 300TE
You need to ask TemjinX2 the "buzzing" question. He is the forum authority on seat modules. The only reason I posted was I was researching the pedal brake light switch deletion to BAS activation for another member & thought while I was reading 168 pages I would look for the seat module - but to no avail.
BTW - I don't know anybody in South Africa that has ever had this problem so I wonder whether there were not multiple suppliers of this module.
Mike says made in Portugal due to Portuguese language on components. I think more likely made in Brazil when many W203s were manufactured for the US market there.
BTW - I don't know anybody in South Africa that has ever had this problem so I wonder whether there were not multiple suppliers of this module.
Mike says made in Portugal due to Portuguese language on components. I think more likely made in Brazil when many W203s were manufactured for the US market there.
Michael
#47
Super Moderator
Understood. If your car was German built then likely they were European sourced. It's just that in countries like South Africa with their own plants the local content is fairly high. South African built W204, as an example is approx 47% by weight local content. W203 was similar.
German built cars usually show their content on the door jam stickers.
German built cars usually show their content on the door jam stickers.
#48
Junior Member
Join Date: Jan 2006
Location: Boston, MA
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
'95 e320 Wagon, '92 300TE
I did some more searching. Looks like these folks can rebuild the unit for those who aren't so great with wiring....
http://www.bba-reman.com/content.asp...Control_Module
http://www.bba-reman.com/content.asp...Control_Module
#49
MBWorld Fanatic!
Thread Starter
Join Date: Dec 2007
Location: Corona, CA
Posts: 5,034
Likes: 0
Received 6 Likes
on
6 Posts
03 g35 coupe...........02 c32 Sold
Yeah, this would make sense (that they tightened up quality control)...I've yet to hear of anyone with a 2003 or 2004 who has experienced this problem. Again, I just bought an '04 C320. Will I hear a buzzing noise when it starts to malfunction and pull too much from the battery?
I'd rather not fix it if it's not broke but would like to know what to look for.
thanks again,
Michael
I'd rather not fix it if it's not broke but would like to know what to look for.
thanks again,
Michael
#50
Briliant job but I cannot help to wonder that the brown wire and the brown/red wire is the CAN L and CAN H wire.
Now I have seen another fix (not better than this, however easier), where one of the wires has a permanent live and the other has a ignition live. The other fix involves chopping off the brown wire and capping it off and connecting the the other side of the wire into a splice on the brown/red wire.
However, what I can't help but wonder, asthe wires involved here are the CAN wires, does it not affect any other systems whichever mod one decides to carry out?
Now I have seen another fix (not better than this, however easier), where one of the wires has a permanent live and the other has a ignition live. The other fix involves chopping off the brown wire and capping it off and connecting the the other side of the wire into a splice on the brown/red wire.
However, what I can't help but wonder, asthe wires involved here are the CAN wires, does it not affect any other systems whichever mod one decides to carry out?