Set of rear Brembo cross drilled rotors that were on a CLK. I believe these should also fit W210 and W202. I no longer have a need for them since I upgraded to a BBK for the rear. These rotors have approximately 8500 miles. These were purchased from a Brembo distributor.

I am asking only $125. Prefer a So Cal buyer, but willing to ship at buyer's expense.

still available.

give me a day or two benz, may have a buyer for you .

flip

I"m interested. Will this work with the brakes I have on now? Or do I have to purchase additional parts?

do you know if these will fit on a W203?

can you post the dimensions, like width and thickness of the rotor. I am curious to see how close they are the the C32 rear brakes.

mig888- sounds good.

Chi500- They will work with your stock calipers. No need for additional parts, unless you have a need to change out your brake pads.

pshek- I don't think that it will work on a W203. W203 & W209 share similar chassis. Same thing for W202 & W208...similar chassis.

Dead Ringer- I will post some pics tonite and take some dimensional measurements.

I'm interested, but I'll need cross-country ground shipping. Let me know.

While you're at it, post some pics of your car!

Still interested.

Sorry I did not get a chance to post pics....had a busy weekend. First thing I will do when I get home today...pics.

Did not have my micrometer at home to measure the thickness of the rotors (I will post the thickness later), but I did take some pics as requested....

looks like the holes are sweeping the wrong way, dang...

[QUOTE=Dead Ringer]looks like the holes are sweeping the wrong way, dang...[/QUOTE

Pics are showing front and back side of same rotor, holes are sweeping in the right direction.

How come there are 6 holes in that rotor ?

HOT CLK !!!

looks like the bottom pic has the hat facing outward ( ie the way it would be mounted) and has the hole sweeping forwards, meaning that if it was mounted on the drivers side they would be "throwing" forward, mine are throwing backwards. Maybe the lower pic is showing the backside and I need to get my eyes checked..

Not sure what to tell you at this moment, with regards to direction of holes....I will take a pic of both rotors side by side for comparison.

c43amg-I believe the sixth hole is to secure the rotor, other five holes are for the lug bolts to secure the wheel.

What sort of suspension do you have on that CLK? I like the amount of drop.

Kleeman springs and dampners....gives you approximately .75 inch drop, plus I have changed out my spring pads.