enjracing

hi all, there is a great set of wheels on here that i want to buy but i'm a tad concerned on the rear offset. it's an 11.5" rear with a +56 offset. i'm lowered and i definitely don't want to be even a mill past being flush with the outer-edge of the rear fender. would i be ok with this offset? tnx.

Skilly

Assuming you have a GT/GTS, that's 18mm pushed outward. 15mm is easy - fits no problem. The best I can tell you is *maybe*. Its close really - the fact that you are lowered means you are already sitting with camber. If given the chance I would test fit; you are super close to rubbing

dlefty

Since we know 12” width at et62 is perfect on a GT/GTS, that would be same as an 11.5” et56, so you should be fine.

Skilly

the math checks out

Eyeman89

The wheels you are talking were made by BC specifically for a GT/GTS. BC is a very reputable aftermarket wheel maker. If I could figure out what to do with the great stock wheels I'd buy them.

dlefty

I know

SheryarYO

buy them and figure it out later

enjracing

haha, tnx gents!