Brake Pad Sensor 2006 E350 4matic
#1
Newbie
Thread Starter
Join Date: Aug 2015
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
2006 E350 4matic
Brake Pad Sensor 2006 E350 4matic
My mechanic changed the brakes and rotors all around, and replaced the 2 brake pad sensors passenger side front and rear. There is apparently some confusion about whether there are 2 or 4 sensors, but he said there was no place to plug them in on the drivers side. The warning light to check the Brakes, visit workshop light still comes on. He changed the sensors out twice and it keeps happening. Any tips from the forum? Does the idiot light need to be reset somehow? He is a very competent mechanic but doesn't work on many Mercedes.
#3
SPONSOR
#5
Out Of Control!!
Join Date: Jul 2003
Location: North Scottsdale, AZ
Posts: 15,903
Received 4,417 Likes
on
3,146 Posts
'71 Pinto
MY06 211.087 (e350 4matic) 1 front right, 1 rear right – both part # 2115401717 provide bulletin attachment to your tech.
Last edited by konigstiger; 08-27-2015 at 03:05 PM.
#6
Junior Member
There are only two sensors (both on right/passenger side) and I do not believe they need to be reset. When I did mine, it was just a matter of unplugging the old and replacing with the new. I used OEM sensors, not sure if its actually any better than aftermarket.
#7
Out Of Control!!
The brake ware sensors are read in to the front SAM, therefore assuming all connections have been checked I would look to the drivers side SAM and a potential issue.
However if your guy does not have the diagnostics----live with it!!
However if your guy does not have the diagnostics----live with it!!
Trending Topics
#8
MBWorld Fanatic!
SBC. Run short test and have faults read..... sbc unit needs to probably be updated, which in turn means it'll need to be replaced within the next year or so. Good luck!