Newbie
Quote:
Yes i have found the replacement but whats its strange to me is that i dont have neither incoming voltage to the connector. Originally Posted by JCM_MB
Well, if the resistance is infinite, i.e. open circuit, the magnet is toast. Have you seen the magnet replacement on sale anywhere? The one I used should be similar, but I have never worked on that specific pulley. Not certain the diameter would be same as the one I used.
What can it be ?
CaliBenzDriver
Out Of Control!!
close
Today
- Join DateApr 2019
- LocationSilicon Valley
- Posts:11,921
-
iTrader Positive Feedback0
-
iTrader Feedback Score(0)
- Vehicle(s) I driveW212 MY'14 M276-3.5NA @75kMi
-
Likes:7,016
-
Liked:6,775 Times in 4,764 Posts
Quote:
What can it be ?
Be aware the SAM Module is smart enough to shut down line controls if it senses "no load" open circuit.Originally Posted by invictus 23
Yes i have found the replacement but whats its strange to me is that i dont have neither incoming voltage to the connector.What can it be ?
It is unlikely you have both an open electromagnetic clutch *AND* a bad line driver (mosfet or relay).
> TESTING...
-- Use the scanner to energize your clutch coil
-- Use a test light bulb to load the coil circuit to let SAM activate it.
This test should help you confirm only your clutch coil is bad, right?
