My Comand 16x9 facelift retrofit on my S55 AMG.
Read more: https://mbworld.org/forums/s-class-w...#ixzz37XounbNc
Question for GPS Antenna
-------------------------
I would like to use original GPS instead of aftermarket purchase. Trying to install and run cables through fittings is too intrusive.
If I make or buy an adapter cable to fit the GPS connector for COMAND 2.5 to COMAND 2.0. Would it work ?
CRC9 (or MCX. Whatever the original connector) to HRS GT5-1S grey connector. It would cost the same but it will be cleaner.
On all these discussions nobody mentioned if it was a connector problem or old Antenna is somehow not compatible with COMAND 2.0 other than the connector
Question for Speed Converter
--------------------
There are 6 cables on the speed converter. Ground and 12V is obvious. Remaining four is inline for Canbus HI and Canbus Lo.
So you cut the harness one goes to the connector side the other goes to the CANBUS for each. 4 cables
Color Coding is on the device for two. In or out part is not clear
Can Lo - To C2 Connector Pin 8- What Color is connected from the speed converter ? Blue or Blue-Black Striped
Can Lo - On the Harness White cable - Which color is connected from the Speed Converter ? Blue or Blue-Black Striped
Can Hi - To C2 Connector Pin 9 Green Cable - What color is connected from the speed converter ? Yellow or Yellow-Black Striped
Can Hi - On the Harness - Which color is connected from the speed converter ? Yellow or Yellow-Black Striped
This question is asked many times, I haven't seen this answered or described in a write up. If anybody knows, I would be glad. Trial and error doesn't sound good in this case
Thanks,
Last edited by levitas; Aug 29, 2016 at 04:10 AM. Reason: Add more info
The Best of Mercedes & AMG
i get the Comand 16:9 System for my w220
but i Need the Speed Interface to built in my
W220 !! Please help me ! I cannot buy this Speed Controller!!
Thanks for your help

Before the swap..

Old AC console..

First remove this tray...

Then just losen the center panel softly..

Take out the old Comand..Trim the inside panel a bit..

Move some pins in the C2 conector and add the speed signal adapter,gps antenna and put the new Comand and wood palens in place..
Mount the new AC panel with matching chrome rings..Plug n play..

All in place..All working..

New AC with the chromerings..

What you think od the swap in my S55 AMG ?? (The AMG emblem is removed now.) I just LOVE the swap and HATE the old look...
This makes me wonder if it possible to upgrade any further from comand 2.5 to whatever would be newer and compatible.
https://mbworld.org/forums/cl-class-...ml#post7824748









Im also desperate for it.



