When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Pls help! Rear seat belt plastic guide ring collar broke in two and stuck in hole
Hi all,
I tried to replace a broken rear seat belt guide ring collar, but I turned it the wrong way and it snapped into two. The lower half of this plastic collar is currently stucked in the hole (as shown in pic below) and I have absolutely no idea how to get it out.
JB Weld is much stronger than Super Glue. You may want to put a ring of JB Weld on the broken piece, plus a few dots of Super Glue (not on top of the JBW) since that sets up quickly. After 24 hours it should be stronger than before it was broken.
He is not looking to repair, the piece is already broken somewhere else, he just needs to get it out without dissambling the seat (which is not too bad but will take a couple of hours).
He is not looking to repair, the piece is already broken somewhere else, he just needs to get it out without dissambling the seat (which is not too bad but will take a couple of hours).
Even if this is true, the JB Weld/Super Glue trick will work after the JB Weld has been set up for 24 hours. He can then push and twist the piece out of there.
Mercedes SLR McLaren 722 S Is Extremely Rare Example Modified by McLaren
Slideshow: A one-of-one U.S.-spec Mercedes-Benz SLR McLaren Roadster became even rarer after a factory-backed transformation at McLaren's headquarters.
