Originally Posted by GregMB

Just start pushing buttons.....what's the worst that could happen?





If you are too lazy to read what already been shared, I'm pretty sure we're too lazy to spoon-feed you that same exact information.

-G

Originally Posted by GregMB

If you are too lazy to read what already been shared, I'm pretty sure we're too lazy to spoon-feed you that same exact information.-G

Originally Posted by Lori3657

I think he means the fogs will work like the new cars do. The fogs don't actually turn.

They are connected to the steering sensor. When you are turning left, the left fog light will come on...etc.

At least i am assuming that's what he means.

Originally Posted by Ag02m5

Hey STAR gurus. We have adjusted my 07 e63 a few times with STAR without issue. We went for a third time to even it up and now it won't retain the settings. It isn't particularly low and the STAR system says that the settings were succuessfully saved. However, after making adjustments via the raise/suspension buttons, the car lowers back down to a point significantly lower than where we had it set. Any ideas? Thanks. RT

Originally Posted by aleksandar1099

So I thought I would help out a few MB brothers with a couple star diagnostic tutorials...

First, Lowering the car.
Get to the 211 Section

You will get to the main menu

Then go to Func perf by more than...

Then Chassis

Then Level adj

Then Suspension

And here is where people have problems, they just go to actuations and then lower it, IT WILL NOT STAY LOWERED this way, you have to go to initial startup

Then Initial with manual settings

Then F2

Here you will see a screen that shows the voltages which correspond to the height of the vehicle. they must be within the given ranges in the left hand column. use the + and - buttons to lower the car (In my screenshot I am in the car with a friend in the back seat, so that is why it is at 3.27, it should not exceed 3) Then hit F2

Enter in these inclination angles and if the car is within the voltages supplied in the page before, the car will accept the new lowered setting, if not it will reject it.


Now, how to activate the unlock and lock beep (honestly, one of the best mods to do if you have an older model e55 )
First Control units

Then Body

Then rear SAM

Then Control unit adaptations

Then national version of ATA function

At this screen you will see a pull down menu with a list of different regions on it. The only ones you need to worry about are USA with buzzer and Netherlands. If you choose USA, i will give you three short quick beeps when you lock the car and one short when you unlock it. Netherlands will give you three longer beeps when you lock the car and one long when you unlock it. Personal preference on which one you like. Then hit F3

Then F3(YES)


Hope this helps out some people. I really did not find a good DIY for Star Diagnostics, so I thought I would help out!

Thanks
Aleks

EDIT: Info for -10 Mod added

Originally Posted by cwmateiuc

Did you really have to quote the whole thing?

If you read, you'll see how much dealers charge on average for it.

Originally Posted by pearlpower

Lowered a members E63 amongst a few other options. Found and activated a sunroof memory function. Essentially once you open your sunroof and leave it at a spot for a few seconds, the next time you auto open, it will move to that position and stay. Pretty cool. Will check my E55 to see if it's in there also, just do not use my sunroof often.

From memory.
control units/body/overhead control/pano/adaptions


Also interesting was the fact that there was an auto close function for the pano roof listed in the menu, yet even enabled could not get it to auto close. From what I understand these cars do not have a pinch strip so auto close was not an option, yet in STAR under pano roof, it's there......

Originally Posted by Polar Bear

And you are correct, there is no way to enable the pano auto rain close.

Originally Posted by Benzer0matic

One thing I haven't tried yet is to set it to ROW to get the pano roof auto rain function to work.

Originally Posted by munich55

Can somebody explain me how i can Eliminate the Seat Belt alarm ?
Thx