Thanks to Bruce at TTM for hooking me up with these. Super great guy who makes me wish I lived back in NYC again!

Install is pretty easy if you can turn a wrench and drill 2 small holes.

I really think this mod is a must have as our cars stuggle so much for air. Any help they can get is a plus. Obviously I don't feel anything down low but up at higher speeds, I have to be getting some benefit from that focusing of the high air flow. Feels great to me! No worries on water or snow as I just went through a massive snow storm (see my 650+hp in the Snow post for pics) and not a single problem.

Thanks again to Bruce! Nice simple clean mod!

I will let him answer questions from here on cost, install, shipping etc.

**OH, I was driving up to take pics and noticed I had an intercooler hose going bad on me. It got the engine bay and upper hood pad dirty so I hosed it down quick and shot the pics. Sorry for dirty engine bay. Feel bad next to you California guys. You can EAT off your cars man!

Super clean looking! Kinda wish I would have gotten mine in black now.

Looking good Jim....

Looks great good sir!

Looks hard.

How much and where can we get our own?

Very nice! Looks pretty clean to me.

Looks good,how much do those go for?

Sweet!

Would these be of any benefit for someone with all stock intake gear(intake tubes, throttlebody)? Do they bolt up to stock setup without any issues?

Thanks,
Todd

Damn. where can I buy these?

http://www.ttmotorsports.com/contact.htm

Send Bruce an email, or call him.

group buy anyone ??

Dyno results?

All that Carbon Fiber...drooollllll!!! Looks great, Jim!

Very Nice as usual James. Happy Thanksgiving _PTEngineering

Looks sweet! you can tell by the design that that these will help direct air flow and make some top end power.

Air scoops like these are really going to shine out on the road where the air flow and pressure are high. On a dyno even with big fans is no were near the same air flow/volume that you see at 60+ mph.

That's one clean e55 Jim!

Do you have any more photos of your rig Jim ?

Awesome Jim! I currently have a set on my car and love the way it looks. As Nick was saying, this is a mod that won't show a difference on a dyno.

Nice job Bruce, you better start mass producing these bad boys!

How do these hold up on top speed runs?

can they take the wind being ramped into them?

Hey Jim,

Why does your engine bay look just like mine?

BTW, Happy TG

Love the scoops!!!

BTW, your guys' engine bays are ridiculous

How much for them?

Sweet!