List of LTH (Long Tube Headers) Manufacturers for C63?
#101
MBWorld Fanatic!
#102
Former Vendor of MBWorld
Headers + tune
CLS63 (base line with RENNtech shorty headers and tune)
MBH headers taking some heat
http://www.youtube.com/watch?v=dXLsz...layer_embedded
http://www.youtube.com/watch?v=BRZNw...layer_embedded
I'll see if I got more charts kicking around, I'm sure I do.
CLS63 (base line with RENNtech shorty headers and tune)
MBH headers taking some heat
http://www.youtube.com/watch?v=dXLsz...layer_embedded
http://www.youtube.com/watch?v=BRZNw...layer_embedded
I'll see if I got more charts kicking around, I'm sure I do.
Last edited by MBH motorsports; 08-03-2010 at 01:19 AM.
#103
^^^That's my chart on top. Note that all runs were done with secondary cats intact and primary cats replaced with test pipes. Here is the original thread:
https://mbworld.org/forums/c63-amg-w...o-results.html
https://mbworld.org/forums/c63-amg-w...o-results.html
#105
Former Vendor of MBWorld
#107
MBWorld Fanatic!
mbh your headers look awesome, only thing is, you make them for lhd, i would of been interested in a rhd pair, but by the time it gets to australia and fitted it would cost me $7000aud, which is far too much money for headers only. if they came in at or under $4kaud landed i would of been interested, but knowing how much MHP sells theres for, it would of been impossible.
h.
h.
#108
Former Vendor of MBWorld
#109
PREMIER SPONSOR
Join Date: Nov 2001
Location: Huntington Beach, CA
Posts: 2,922
Likes: 0
Received 0 Likes
on
0 Posts
None fast enough!
#112
It could be the glare in the pic or the fact that I need a new laptop. There aren't any crimp bends or pipe deformations in the pass side header are there? For the life of me no matter how close I get to the screen I can't tell one way or another. Otherwise looks good!!edit: sorry forgot you were in Aust and are RHD! That must be for the steering shaft. Doh!
Last edited by RStevens63; 08-05-2010 at 12:10 AM.
#116
ANy other input im just trying to figure this out here mkb headers u must remove motor mounts for install seems like as well as Renntech long tubes i think from some research im doing
#123
Former Vendor of MBWorld
#125
MBWorld Fanatic!
Pipes are 1 7/8in 3in collector. The exhaust is 75mm in size so just shy of 3in (2.95in), i am happy with it. I have to say the quality is excellent. Just to let you guys know i didnt buy my exhaust from cargraphic, how ever it is the same exhaust from what i can tell.