NAFT1

I'm not usually excited over wheels, but those are ****.

v8sonly

Hmm, never thought about that. They were on there from the factory, I just figured it was to prevent flexing and distortion of the pipes.

illest

Got some headers.

C2 Turbo

Installed a Sprint Booster

Jonas Blomfelt

Done some wiring

eurochargedw210

Installing this bad boy

Michael Weiss

I was expecting much more rust in the back but it wasn't too bad

eurochargedw210

Recharged my ac system. Finishing painting my e63 calipers, waxed my car. Also test fitted my E63s wheels. They fit perfect in the rear, needs a 5/7mm spacer up front.

Tall Giraffe

Tell us more about the SHR transmission and are those 19" E63 wheels? Have a full side shot?

I debated those wheels and the propeller wheels but went with the 2011 E63/ CLS63 split spokes.

eurochargedw210

Just their base model build. Nothing fancy, shifts great and very quickly.

front wheels need a 5/10mm spacer to fit. Rears fit no problem.

illest

Installed my Kleemann headers over the weekend. I was just as complicated as everyone says. Luckily no studs broke off in the process. It not much louder than before.
I am running the following
headers down pipes xpipe resonator (might remove this later) muffler

eurochargedw210

I am running those header, no cats, x pipe and no res. I still have my muffler. It sounds great, zero drone

ACB_E55

eurochargedw210...

Do you happen to remember what the offset is for the front and rear E63S wheels? Thanks...

eurochargedw210

37 front 52 rear. Front needs a 5/7mm spacer.

rear fits perfect, could even use a 10mm spacer to get closer to the fender

ACB_E55

Love it when all the warning lights go off...LOL.

Replaced...

C2 Turbo

Very nice... Please tell us about those calipers, what car did they come off and did you have to use any spacers/brackets etc? Also please posts a side view of your car to see the wheels, 19" right?

Thanks

Zoraone

Hey! That's my old car. Love it. Glad it is going to live on and be properly restored.

Kind of missing it. Doubt I'll ever get a chance to own one again since the prices are starting to go up.

Dustin

eurochargedw210

W211 e63 calipers. Will need to drill out my knuckle to 14mm, use a small spacer and clk63 rotors.

wheels are 19s from an e63s w212, will get pictures in a month or so once I get tires.

sy1616

I DROVE IT! After sitting, in favor of my e39 M5 and some other toys, for a couple months, I detailed it and put 30miles on it. Loved it, drives like new. About to hit 60k miles. Great car!

eurochargedw210

Water pump, belt, idler pulley, and tensioner.

eurochargedw210

Custom intake out of carbon fiber!

LUNDY

Awesome. Looks like mine but yours has less miles.

illest

Bought a set of 2 rear monos, with some curb rash. Test fit them on the front, they fit just barely. Need to get some tires and I'll try running a square setup.

Tall Giraffe

Interesting, so that is a ET35 in front? With spacers? What tire size will you be using?

illest

I am going to try a 245 40 18 with a 5mm spacer. The wheels fit without a spacer but they are very close to rubbing on the inside.