TCU swap out idea




If you have a "2.8ME ECU & touch shift +/-,Trans. with the EGS52", it well be easy programmed.....
ZAYED,,
Trending Topics
The Best of Mercedes & AMG




"Kleemann - MKB - Renntech", they all said its impossible to tune or programmed the EGS51, which you & i already had it,, Eurocharged may only
reset & reflash it for you,,
*Pls. read careFULY the threads from Abalone & GMP performance:-
1) https://mbworld.org/forums/w211-amg/...ne-my-tcu.html
2) https://mbworld.org/forums/w210-amg/...o-upgrade.html
3) https://mbworld.org/forums/performan...-upgrades.html
ZAYED,,
Last edited by cm60k; Sep 23, 2012 at 06:19 AM.
Roger – We can only program the EGS52 and EGS53 control units. The EGS51 cannot be flashed. Some W210 E55’s have the EGS52 control unit and some have the EGS51 control unit. Thanks for checking!
Jerry Thornton
Eurocharged Performance
www.eurocharged.com
(281) 398-9700 - Office
jerry@eurocharged.com
So there you have it! I'll hunt for an EGS52 version to drop in my ride to replace the EGS51! There's got to be one out there.




Thankss aloooot for your time & sharing this value info.,,
*While you have a touch shift +/-,, you just need to put EGS52, calibration & update it with the ECU,, you should do that in the dealer or a very
professional shop(who knows about Star & SDS).......
ZAYED,,
Last edited by cm60k; Sep 26, 2012 at 12:34 AM.
I found an EGS52 type TCU for my E55 this morning and bought it for $100 delivered. One of the years and models it cross-references to is a 200 E55 AMG. The guys at Eurocharged say they're not "married" to a particular vehicle so I think I'm in luck, finally. My car must have been one of the earlier ones manufacturered in 2000 or late 1999, for that matter. So, when it arrives, I'll swap it in to test it. Then, if it's OK, I'll do a "sneaky reset" and send it in to EC for them to flash. by then, I'll have my ECU flashed by them, so I'll be ready to rock 'n roll!




What's the part # of that TCU you bought...?, is it : "027 545 12 32" or "030 545 23 32".....??,,
Also you need to be sure that TCU(which you ordered),gets-off from any models that had 2.82 diff.,,
It may not works if you swapped without calibration with ECU.......!!
By the way; is your ECU started with: "02xxxx" or "113xxxx".....???
ZAYED,,
What's the part # of that TCU you bought...?, is it : "027 545 12 32" or "030 545 23 32".....??,,
Also you need to be sure that TCU(which you ordered),gets-off from any models that had 2.82 diff.,,
It may not works if you swapped without calibration with ECU.......!!
By the way; is your ECU started with: "02xxxx" or "113xxxx".....???
ZAYED,,
The TCU I just bought is from a 2002 E430 and its part number is 0305452032. The part number of the ECU in my car is 0265453132. BTW, I spent quite a bit of time with Adam Chisum of Eurocharged today via phone and computer link today trying to do a remote flash on my ECU. We just can't get my laptop to the read the VIN and ID of the ECU from the OBDII port. Adam says this is a rare event. As a result, I'm going to send my ECU in to be flashed when my new TCU arrives. Adam thinks there will be no problem getting both of them flashed. (BTW, Adam is one hell of a good guy!)
Wish me luck,
Wile E. Coyote




I believe with EC reflash & calibrate, it well be great job,,
Gooood Luck.....(
-
)ZAYED,,
Last edited by cm60k; Sep 28, 2012 at 02:46 PM.




The TCU I just bought is from a 2002 E430 and its part number is 0305452032. The part number of the ECU in my car is 0265453132. BTW, I spent quite a bit of time with Adam Chisum of Eurocharged today via phone and computer link today trying to do a remote flash on my ECU. We just can't get my laptop to the read the VIN and ID of the ECU from the OBDII port. Adam says this is a rare event. As a result, I'm going to send my ECU in to be flashed when my new TCU arrives. Adam thinks there will be no problem getting both of them flashed. (BTW, Adam is one hell of a good guy!)
Wish me luck,
Wile E. Coyote
"!!..After check, can’t do the TCU..!!"
*I hope Adam can do it, what do you think....
!!??ZAYED,,
Last edited by cm60k; Oct 4, 2012 at 01:35 PM.
There is clearly some confusion going on about this. My correspondence with Jerry indicates that the EGS52 type TCU that I purchased is programmable. He did tell me to test it for normal operation in my car before I send it to EC. Like I said, we'll see.
Wile E. Coyote




,, i thought you already tested the TCU(which you purchased),, its a little complicated thing to me,, cause the only disadvantage thing with me, that i don’t have a touch shift +/-........
ZAYED,,
I finally got the TCU but the parts yard sent me an EGS51 type because the exact one I purchased (EGS52type) somehow got water damaged and was thrown out! They didn't know what I was planning so they thought they were doing me a favor by sending the one that is OEM for my car. So, it's on its way back for a refund. The only other TCUs out there that might work are around $300 used. Too much money and time at this point. Yesterday, I contacted Jerry and blew off the TCU tune and he already sent me a refund for the programming! (He is a super guy!) So, I'm just going to send in my ECU and leave it at that. So, this puts an official end to this thread. Thanks for all your help.
Wile E. Coyote
Last edited by Wile E. Coyote; Oct 9, 2012 at 08:31 PM.




I finally got the TCU but the parts yard sent me an EGS51 type because the exact one I purchased (EGS52type) somehow got water damaged and was thrown out! They didn't know what I was planning so they thought they were doing me a favor by sending the one that is OEM for my car. So, it's on its way back for a refund. The only other TCUs out there that might work are around $300 used. Too much money and time at this point. Yesterday, I contacted Jerry and blew off the TCU tune and he already sent me a refund for the programming! (He is a super guy!) So, I'm just going to send in my ECU and leave it at that. So, this puts an official end to this thread. Thanks for all your help.
Wile E. Coyote
"Glimmer of Hope".....

ZAYED,,
Last edited by cm60k; Oct 9, 2012 at 11:04 PM.


